What is the governor on a go kart?

What is the governor on a go kart?

The governor on the Predator 212cc engine limits the speed of your go-kart by regulating the fuel intake once the engine hits 3,600 rpm.

How do you change the governor on a Briggs and Stratton engine?

First, loosen the arm until it is moving freely. Next, open the throttle to full capacity while making a note of which direction the arm moves in when the throttle moves through it. Once the throttle is fully opened, move the governor shaft in the same direction the governor arm traveled.

How does the governor work on a Briggs & Stratton engine?

To control engine speed, a mechanical governor uses gears and flyweights inside the crankcase to detect changes in the load and adjusts the throttle accordingly. When the engine load increases, the crankshaft spins more slowly. This leads the flyweights to relax and the throttle to open back up.

How do you know if governor is bad?

Easy to tell if the Governor is Toast. Run the engine at 3/4 throttle, and see if the governor arm is applying pressure by manually pushing the arm away from the carb. No Pressure=Bad Governor. Otherwise, You should be able to get it working correctly by adjusting the governor and the Throttle Screw.

How do you adjust the governor on a go kart?

Turn the nut driver counterclockwise to rotate the governor shaft to the full-throttle position. Tighten the clamp bolt or nut with the wrench. Reduce the throttle setting by first loosening the clamp bolt or nut and rotating the throttle plate clockwise until it stops.

How does a Briggs and Stratton engine governor work?

When Briggs & Stratton governors are adjusted properly, they keep your speed steady regardless of engine load (the amount of work the engine must perform). When powering a lawn mower, engine load can be affected by hills or height of grass.

What happens if you adjust the Governor of an engine?

In the event that they do need adjusted, here is how to do it. One of the most important parts of your engine is the engine governor. An improperly adjusted governor can shorten your engine’s life. If engine speed is not controlled, the engine will destroy itself.

How does the governor spring work on a car?

The governor spring is precisely calibrated for an engine that has full air flow going through it. If the air flow is blocked it can over speed the engine. First The governor shaft should always be turned in the same direction the governor arm turns to open the throttle wide open.

How do you adjust the governor on a LEV engine?

For example, on Tecumseh TVS, LEV, TVM, TVXL and other similar engines, the governor arm rocks in the counter clockwise direction to close the throttle to idle. To adjust the governor, you would loosen the screw on the bottom of the governor arm and push the governor arm so the throttle is wide open.